I put the rear mean streak on. I used the mean streak caliper and brake caliper bracket. I measured the width I would need for the mean streak bracket with the c10 wheel setup how it normally comes. I measured the amount that would need to come off the bracket and instead of bringing it to a lathe because frankly I’d never do it. I work too much. I used a square to mark how much needed to come off and eyeballed it to get it as flat as I could I had to trim a little extra off the section the of the bracket that the caliper presses against to get it to line up with the rotor just right. Again I just eyeballed it and everything worked great. Tightened the spring on the progressive shock as much as possible and raised the fork tubes a half inch in the triple clamps. Much better stability and handling I still wish it was faster. I’m going to send a set of gpz900 cams to Canadian chrome to have the power cams specs ground into them. Not sure what to do with the 17” GPz front wheel. Remove the black paint and polish it to match or just paint the front and rear black.
View attachment 36484View attachment 36485
View attachment 36484View attachment 36485