• Can't post after logging to the forum for the first time... Try Again - If you can't post in the forum, sign out of both the membership site and the forum and log in again. Make sure your COG membership is active and your browser allow cookies. If you still can't post, contact the COG IT guy at IT@Concours.org.
  • IF YOU GET 404 ERROR: This may be due to using a link in a post from prior to the web migration. Content was brought over from the old forum as is, but the links may be in error. If the link contains "cog-online.org" it is an old link and will not work.

Appears too easy...

T

toddmo

Big Wheel
My brake light has stopped functioning when I squeeze the front brake grip lever. I am assuming the cause is the $20 switch located below the master cylinder (the brake light works when depressing the rear/foot brake lever). It appears that one screw and a wire connection are all that need to be tampered with when replacing the switch. Could it really be that easy?
 
Todd, Does the rear brake light come one when you push on the rear brake pedal? If so the front brake switch might be bad or just dirty. Spray some WD-40, etc. in the switch and work it into the switch by pulling on the brake lever.
 
BTDT. Yup, it's that EZ. Follow Jay's advice, if it's toast it's no prob to r/r. 01 Conc, Mijami Floriduh OTP 06: http://tinyurl.com/2vk9o2 route map: http://tinyurl.com/4p7pmd
yzdfi9.jpg
yzdfib.jpg
yzdfia.jpg
y6x7zt.jpg
 
You must log in or register to reply here.
Top