• Can't post after logging to the forum for the first time... Try Again - If you can't post in the forum, sign out of both the membership site and the forum and log in again. Make sure your COG membership is active and your browser allow cookies. If you still can't post, contact the COG IT guy at IT@Concours.org.
  • IF YOU GET 404 ERROR: This may be due to using a link in a post from prior to the web migration. Content was brought over from the old forum as is, but the links may be in error. If the link contains "cog-online.org" it is an old link and will not work.

fender extender

R

Roland

Training Wheels
Has anyone tried to install the fender extender with ABS glue and without removing the fender for the install although I would think it can't be that hard to remove the fender.
 
I removed the fender with the wheel still on.  4 bolts on the inside.  It takes a little bit of dexterity and holding your mouth right but persistance pays off and it will come off.  I didn't use ABS glue though, I drilled 4 holes and used 4 small screws.  I'm sure the glue route will look nicer and more factory but i don't even notice the screws. Good luck.
 
I wouldn't do it without removing the fender. Comes off easy enough.

You have to clean and lightly sand the mating surfaces to get best adhesion.

Make sure you align the extender carefully before the glue grabs.

Skeeter
 
I'm sure it could be done without fully removing the fender. But it's so easy to yank the fender, why not just remove it?
 
You must log in or register to reply here.
Top