• Can't post after logging to the forum for the first time... Try Again - If you can't post in the forum, sign out of both the membership site and the forum and log in again. Make sure your COG membership is active and your browser allow cookies. If you still can't post, contact the COG IT guy at IT@Concours.org.
  • IF YOU GET 404 ERROR: This may be due to using a link in a post from prior to the web migration. Content was brought over from the old forum as is, but the links may be in error. If the link contains "cog-online.org" it is an old link and will not work.

LEVER-COMP-CHANGE SHAFT

M

Matt Wright

Big Wheel
Hi all
Just received my new 92051-5005 oil seal, TB132, which is seats on the outside of the Front Bevel Gear Case around the LEVER-COMP-CHANGE SHAFT. It is a rubber seal that's vulcanized to the inside of a metal ring, the edge of which is beveled for insertion into the seating.
I've not removed the old seal (have never done this job, before...)
Any suggestions, advice or experiences would be greatly appreciated.
Thanks!
Matt
 
You must log in or register to reply here.
Top