• Can't post after logging to the forum for the first time... Try Again - If you can't post in the forum, sign out of both the membership site and the forum and log in again. Make sure your COG membership is active and your browser allow cookies. If you still can't post, contact the COG IT guy at IT@Concours.org.
  • IF YOU GET 404 ERROR: This may be due to using a link in a post from prior to the web migration. Content was brought over from the old forum as is, but the links may be in error. If the link contains "cog-online.org" it is an old link and will not work.

2006 Stock Handlebars Low vs High specs

B

bzim7506532

Member
Member
I have a 2006 Connie but I am trying to figure out if I have the low type or the high type. The drawings don't have dimensions and I am having trouble comparing because I don't see any obvious tell-tale sign. Does anyone have any dimensions of what they have and whether it is the low or high version?
 
I would doubt that an 06 has the low version unless someone changed from the stock bars. I believe the low versions came on the 86. I'll go measure in a bit. Posting a pic could be helpful without measurements.
 
On a 2006 you will have the higher handlebars. The lower bars are pretty rare and it's pretty doubtful that anyone would have installed them on an 06..
I "thimk" the low Bars came only on the 86 and 87.

Ride safe, Ted
 
The stock clip-ons on my 2002 are approximately 6" from bottom flange to the top, so a bit over 5" rise to the center of the handlebar.

My understanding is that 1986 was the only year for the "low" ones, which were about 1" shorter.

1000010113.jpg
 
Last edited:
You must log in or register to reply here.
Top