What's the best way to remove the center fairing on the 2010? I started from the top down and finally managed to remove the center fairing but was afraid I was going to break the locking tabs that hook into the lower fairing. Should I have removed the center and lower as one piece? Thanks for all feedback! Wayne
-
WOULD YOU LIKE TO BE ABLE TO POST? REGISTER FOR COG MEMBERSHIP
All registration must be done through the club's main webpage: To register / join COG, click here
For instructions to convert to full membership, click here
-
Can't post after logging to the forum for the first time... Try Again - If you can't post in the forum, sign out of both the membership site and the forum and log in again. Make sure your COG membership is active and your browser allow cookies. If you still can't post, contact the COG IT guy at IT@Concours.org.
2010 c14 Fairing removal
- Thread starter Mcwayne
- Start date
The new locking tabs on the lower section of the 2010 fairing (where the colored panel meets the black lower section) are problematic to remove. There is a small ridge on one of them that acts to prevent it from removing easily. You have to work at it to get it loose, but it will eventually release. Once you get it apart, look at the colored tab real close and you will see the ridge line on it that it hangs up on. Sometimes I use a thin plastic tool and push inward on the tab while lifting up on the panel to get it to release.