I putted up to Whitehorse Gear today and picked up a simple RAM mount and installed my Zumo in about 30 minutes using only two hex wrenches and some zip ties. The RAM mount screws right into your clutch mount screws. Here's a link to the $12.50 mount from their web site: http://www.whitehorsegear.com/ram-mount-clutch-brake-single-ball-base Here's a picture of it mounted:
Note: I had an extra ball and mounted it before doing the installation. You can spend an extra $10 and get both as seen in this link. It also shows the standard installation with RAM spacers and screws, which is slightly different from my job. I had a couple of longer hex screws and used them instead of the spacers. http://www.whitehorsegear.com/ram-mount-clutch-brake-double-ball-base Next, I removed the center piece on the top of the gas tank and the right top piece of the fairing. You may have to **** around with the plastic pin under the windshield to get top of the fairing off. My bike is brandy new and I discovered that the pin was missing. In this case, it worked out to my benefit. Under that piece you can easily find the wires for your power outlet. The plug in conveniently where you can easily get at them. I simply stripped the wire back a bit on the Zumo cable and inserted it and re-plugged the two connectors. Make sure you match the red wire from the power connector with the red wire from the cable. Here's a lousy picture, but you will get the idea.
I used some zip ties to secure the wire and get it out of the way:
And Voila! Done!
Note: I also use the short mount arm I had on hand, so my cost was $12.50, but you can buy one for $11. Here's the URL So... While I have one of those fancy rigs coming from Murph, I managed to do the whole job in less than a half hour for $12.50 plus the parts I had laying around from my last bike.