Day off from the hospital, at least until 2130, when I’m back on call.
Continuing the mock up of my new driving light mounts. So far looks good. Had a coworker weld a cap on a 1” square aluminum stock. Going to make my own brackets out of thicker aluminum than shown.
Paint black on the finished brackets.
Drill hole in cap of square and attach to bracket.
Square stock will only extend out about 4.5” and will be wrapped in black vinyl.
Lights going on are small Amazon LEDs I’ve been using on my SNARF mounts.
Figured it is worth a try and if it doesn’t work, I’m only out of $20.
Continuing the mock up of my new driving light mounts. So far looks good. Had a coworker weld a cap on a 1” square aluminum stock. Going to make my own brackets out of thicker aluminum than shown.
Paint black on the finished brackets.
Drill hole in cap of square and attach to bracket.
Square stock will only extend out about 4.5” and will be wrapped in black vinyl.
Lights going on are small Amazon LEDs I’ve been using on my SNARF mounts.
Figured it is worth a try and if it doesn’t work, I’m only out of $20.
Last edited: