• Can't post after logging to the forum for the first time... Try Again - If you can't post in the forum, sign out of both the membership site and the forum and log in again. Make sure your COG membership is active and your browser allow cookies. If you still can't post, contact the COG IT guy at IT@Concours.org.
  • IF YOU GET 404 ERROR: This may be due to using a link in a post from prior to the web migration. Content was brought over from the old forum as is, but the links may be in error. If the link contains "cog-online.org" it is an old link and will not work.

Little rubber washer/grommet under fuel tank

F

Fenris38

Tricycle
Yes, I lost it! I know, I know, "be careful when removing fuel tank not to lose the little washers under the screws at the base of the fuel tank," nonetheless, I managed too. Any suggestions as to where to get one, as the dealers here can not find it on the schematics/diagrams, and I have had no luck with the hardware store route either. HELP!!! BTW, anyone looking to duplicate my feat of dexterity and mechanical aptitude, I would highly recommend against it. They are correct, it is damn hard to find these things.
 
try Bike Bandit http://www.bikebandit.com/houseofmotorcycles/1992-kawasaki-motorcycle-concours-zg1000a7-us/o/m3380 this shows for a 92 but all C-10 are the same "If it hasn't killed me yet, it's runnin out of time" COG # 8062 AMA # 1084053 ROMA or Scarlet harlot acording to my wife
 
ax fer a 92075-125 DAMPER,FUEL TANK various ways to stick it on so it don't go bye-bye 01 Conc, Mijami Floriduh OTP 06: http://tinyurl.com/2vk9o2 route map: http://tinyurl.com/4p7pmd
yzdfi9.jpg
yzdfib.jpg
yzdfia.jpg
y6x7zt.jpg
 
Aaron, Is it the rubbers at the rear of the tank where it bolts down? If so, they are on the Bike Bandit fiche as 92075B and 92075D. Hope this helps. Eddie COG Marketing Asst. Sanford, FL 2005 Concours 1969 Triumph Bonneville AMA# 686667 COG# 7073 CDA# 0136 http://picasaweb.google.com/Eddie753
 
... or the same one I lost... the large ones on the front that you slip the tank onto. If they come in pairs, talk to me. I'll buy one from you. Actually this is just one of many parts I've noticed missing on my connie since I've started poking around.
 
It is one of the two little ones that go under the screws at the back of the tank. Thank you all so much for the info!! Rory, quit poking around, that"s how I keep finding all this stuff too!! ;)
 
After really scrutinizing the schematics, i still do not see it. My bike has a thin washer that goes under 92075B it has a champfered center that 92075B fits into. OR, it's a piece of p2075B that has separated over time. Not sure which. I'll try to take a picture of it tomorrow and post (the one I have left at least).
 
ahh.. the one I'm missing is on the other end. It sounds like the seat end rubber on yours has split.
 
You must log in or register to reply here.
Top