• Can't post after logging to the forum for the first time... Try Again - If you can't post in the forum, sign out of both the membership site and the forum and log in again. Make sure your COG membership is active and your browser allow cookies. If you still can't post, contact the COG IT guy at IT@Concours.org.
  • IF YOU GET 404 ERROR: This may be due to using a link in a post from prior to the web migration. Content was brought over from the old forum as is, but the links may be in error. If the link contains "cog-online.org" it is an old link and will not work.

rear engine mount nuts?

Paulie

Paulie

Guest
Guest
Where the heck are the rear engine mount nuts on the L (clutch) side? All I see are threaded holes under the plastic covers. They're on the Engine Mount fiche page as 92210-1080 NUT,LOCK,FLANGED,10MM also on pg 7-2 of the service manual. Thanx guys. 01 Conc, Mijami Floriduh OTP 06: http://tinyurl.com/2vk9o2 route map: http://tinyurl.com/4p7pmd
yzdfi9.jpg
yzdfib.jpg
yzdfia.jpg
y6x7zt.jpg
 
Paulie The lower one is at the 7 O'clock position from the center of the clutch cover. It's a couple of inches forward from the mounting bolt of the exhaust. The upper bolt is underneath the triangular plastic cover that is held on with a single countersunk screw. just forward of the side panel screw. Don't confuse it with the cover for the swinging arm spindle. The Clutch side has the heads of the mountings bolts. Make sure you check the drive shaft side as when they snap its typically the other side that goes. Colin
2606714340100596652OGFlOW_th.jpg
 
You must log in or register to reply here.
Top