What moly paste for front spline?

[kzz1king]

Not sure if I want to spend 50 for the big jug. Is the small one enough for a few things? For the rear spline I have been using Lucas red tacky grease.

 

[cmoore]

I have the small tube in my tool box. It goes a long way.

 

[kzz1king]

I have the small tube in my tool box. It goes a long way.

Honda?

 

[Stasch]

Loctite LB 8012 16oz. Moly 66%

I went to this after the Honda Moly paste became unobtanium.

 

[Bud]

Loctite LB 8012 16oz. Moly 66%

I went to this after the Honda Moly paste became unobtanium.

Buy it here

 

[Fred H.]

If you want the best, get Krytox. Otherwise, Honda Moly works well.

 

[chrismpero]

I bought this, it was a recommendation from Michael cox on FB.

 

[kzz1king]

If you want the best, get Krytox. Otherwise, Honda Moly works well.

That stuff sounds like rocketship material! Impressive.

 

[IBAJIM]

BTW, I have used the Jet Lube MP-50 moly paste for the last 80K miles ( bike now has over 100K miles ) on my old Honda ST1100 and the rear wheel splines still look like new. IMO, any moly paste ( not moly grease ) that has at least 50% moly should do the job well. If lubing is done at a decent interval.

 

[kzz1king]

BTW, I have used the Jet Lube MP-50 moly paste for the last 80K miles ( bike now has over 100K miles ) on my old Honda ST1100 and the rear wheel splines still look like new. IMO, any moly paste ( not moly grease ) that has at least 50% moly should do the job well. If lubing is done at a decent interval.

I am not concerned with the rear wheel as that gets lubed every 6 to 8000. I am pulling the shaft and want to get something good on it because I probably wont do it again!
The Jet lube is on my list but I can only find it in the large can. Might have to bite the bullet.