flying wasp
Bicycle
I was interested in the rear fender eliminator kit. I looked at the service manual on how to remove the rear fender and when I got to the point where it tells me to remove the fuel tank? I thought "why can't I just cut the fender off below the license light? I scribed lines along the angle of the license light about 1/2" below then took the dremel with a cut-off wheel and cut 1" below that just to remove the majority. Then used blue painters tape to lay along my scribe and carefully followed along the tape. Alittle sanding block to clean up the plastic flash along the cut and finished. The dremel cut-off wheel is for metal and it clogged fast with melted plastic...just had to slow it down a bit. Not really a fender elimination,but it does show off more of the rear tire.